Request a Quote

Discuss a Project or describe your requirements below. We'll review your specification, confirm availability and reply with a quotation.

Low-Hydrogen SMAW Electrodes — E10018-D2 H4R

The recorded reference below stays separate from the equipment, spare part and specifications you request.

Selected catalogue reference

Low-hydrogen coated electrodes for low-alloy steel joining, including process piping and offshore-component applications. Select diameter, current and any heat treatment with the base material and qualified welding procedure.

Process and classification
SMAW coated electrode; manufacturer lists AWS A5.5 E10018-D2 H4R.

Applies only to this e10018-d2 h4r coated electrode. Follow the stated diameter, gas, test conditions and qualified welding procedure; do not transfer results to another consumable.

Welding positions
All except vertical down.

Applies only to this e10018-d2 h4r coated electrode. Follow the stated diameter, gas, test conditions and qualified welding procedure; do not transfer results to another consumable.

Electrode dimensions
2.4 × 300 mm; 3.2, 4.0 or 4.8 × 350 mm; 5.6 × 450 mm, as separate source rows.

Applies only to this e10018-d2 h4r coated electrode. Follow the stated diameter, gas, test conditions and qualified welding procedure; do not transfer results to another consumable.

3.2 mm operating current
DC+: 85–160 A; AC: 90–170 A. Manufacturer typical operating procedure, not a qualified WPS.

Applies only to this e10018-d2 h4r coated electrode. Follow the stated diameter, gas, test conditions and qualified welding procedure; do not transfer results to another consumable.

Reference applications
  • Low-alloy steel process piping subject to a qualified welding procedure.
  • Joining carbon-manganese and specified chromium-molybdenum steels after engineering review.
Reference configurations
  • E10018-D2 H4R coated electrode · Scope: Separate supported configuration; diameter and procedure conditions apply. No pooled capability across different consumables.

Requested values remain separate from recorded product specifications.

Describe the actual equipment or spare part, installed maker/model/serial, quantities, units and specifications you need.

1. Contact & company details

Tell us who to contact and where your company is based. Fields marked * are required.

Choose the calling country, then enter your national phone number. Your phone country may differ from your company country.

Company address Optional

2. Product / equipment details
3. Technical & delivery requirements (optional)
Requirements
Requirement files (optional)

0 files selected

    Up to 5 files, 10 MB each. PDF, JPG/JPEG, PNG, WebP, CSV, XLSX or DOCX. Files are private and supplement your requirements. They are retained while your request is active and for 24 months after closure. Please reselect files if the form needs a correction.

    4. Review & submit

    Check your contact details, selected product and requirements before sending.

    We review your specification before confirming a quotation.