Hardfacing Electrodes

Compare E Fe 8 basic-coated electrodes in 2.5 × 350, 3.2 × 450, 4.0 × 450 and 5.0 × 450 mm. Review size-specific current ranges and documented packs, then specify wear duty and repair requirements.

Configure your requirements
Representative covered-electrode form; alloy, diameter, length, hardness and supplied pack are specified separately.
Representative covered-electrode form; alloy, diameter, length, hardness and supplied pack are specified separately.

Sizes & capacities

Manufacturer reference configurations

Compare published specifications for each configuration, then select a reference or enter your own requirements. Supply and the final configuration are confirmed in the quotation.

4 documented configurations. Review one specification at a time; your custom requirements are retained.

E Fe 8 electrode · 2.5 × 350 mm

Reference coated-electrode size and recommended current. Hardness is a typical all-weld as-welded property, not a guaranteed hardness on every substrate or layer. Pack mass/piece count are shown only for the exact sizes listed in the source.

Electrode classification
EN 14700: E Fe 8
Form
Basic-coated stick electrode for hardfacing
Nominal analysis (wt%)
C 0.5%; Si 2.3%; Mn 0.4%; Cr 9.0%; Fe balance
Electrode diameter
2.5 mm
Electrode length
350 mm
Recommended current
80–100 A
Polarity
DC+ / AC
Typical all-weld hardness (as welded)
56–58 HRC
Select this reference →

Your specification

Configure your product requirement

Enter the capacity and site requirements you need. Your selections carry into the RFQ and remain editable before submission.

Essential operating requirements
Additional dimensions and application details

Next: contact details, quantity and delivery. Leave unknown requirements blank and request help in the RFQ.

Applications

Specify the worn component, substrate grade, wear mechanism and service conditions. Describe abrasion, impact, compression, temperature and corrosion separately.

Selection guidance

Choose a documented reference or enter an unlisted requirement. Specify the repair procedure, buffer layers, dilution, preheat/interpass conditions and finishing. Hardness alone does not establish suitability.

Technical notes

Published size and parameter facts remain separate from your requested specifications. Final alloy, process, packaging and documents are confirmed in the quotation. No automatic qualification, stock or guaranteed deposit performance is implied.